Micronics M54E2 PCI/EISA Technické informace stáhnout pdf (Strana 37)

Section 4: BIOS Setup Utility

M54E2 System Board Manual

Figure 4-5: Boot Options Submenu

Boot Sequence

This category selects the order the system searches for a boot disk and can be

set for: A: then C:

C: then A:

C: only

Swap Floppies

This category can be set to remap the floppy drives. It can be set for

NORMAL (default) or SWAPPED. For normal operation, Drive A: and

Drive B: work normally. When “Swapped” is selected, Drive A: becomes

Drive B:, and Drive B: becomes Drive A:.

Floppy Check

When enabled, this category verifies the floppy drive is installed on boot. For

faster booting, select DISABLED (default).

SETUP Prompt

When enabled, this category allows the system to display the “Press <F2> to

enter SETUP” message during boot.

4-8

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 78 79

Žádné komentáře

Micronics M54E2 PCI/EISA Technické informace Strana 37