Micronics PCI/ISA System Board D6-IN Uživatelský manuál stáhnout pdf (Strana 35)

POST Messages

A-1

POST Messages

The following table lists the Power On Self Test (POST) messages,

possible causes, and solutions.

Message Possible Cause

Solution

DISKETTE DRIVE A

FAILURE

Drive A failed or is

missing.

Check Setup and cable

connections.

DISKETTE DRIVE B

FAILURE

Drive B failed or is

missing.

Check Setup and cable

connections.

EXTENDED RAM

FAILED AT

OFFSET: nnnn

Extended memory not

working or configured

properly.

Replace defective

memory.

FAILING BITS: nnnn

Memory failure in

System, Extended, or

Shadow memory.

Replace defective

memory.

FIXED DISK X

FAILURE (where X

=0 or 1)

The hard disk is not

configured or working

properly.

Rerun SETUP and check

connections, or replace

hard disk.

FIXED DISK

CONTROLLER

FAILURE

The controller card has

failed.

Check configuration and

connections, or replace

controller card.

INCORRECT DRIVE

A TYPE

Floppy drive A: not set

correctly in Setup.

Run Setup.

INCORRECT DRIVE

B TYPE

Floppy drive A: not set

correctly in Setup.

Run Setup.

INVALID NVRAM

MEDIA TYPE

NVRAM chip is bad.

Requires repair of system

board.

KEYBOARD

ERROR, or

KEYBOARD

CONTROLLER

ERROR

The keyboard or

keyboard controller

failed.

Check connections. You

may have to replace the

keyboard or controller.

KEYBOARD

ERROR nn

A key is jammed or was

held down during boot.

Make sure the keys are

not jammed or dirty.

KEYBOARD

LOCKED

Keyswitch on the front of

the case is locked.

Unlock the keyswitch.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 50 51

Komentáře k této Příručce

Žádné komentáře

Micronics PCI/ISA System Board D6-IN Uživatelský manuál Strana 35

Komentáře k této Příručce

Související produkty a manuály pro Sítě Micronics PCI/ISA System Board D6-IN